Mazda RX7 FD Series 7/8 Milspec Wiring Loom

Upgrade your Mazda RX7 FD Series 7/8 with this high-quality Milspec wiring loom for use with aftermarket ECU

Plug and play no wiring needed for factory car, remove existing wiring loom and ECU and install new loom and aftermarket ecu. in factory location.

Note: Injector connectors may need to be changed if the standard injectors have been replaced, we can sort before the loom gets shipped for no extra cost.

Milspec Wire: Built to withstand extreme conditions, ensuring reliability on the road.

DR25 Heatshrink: Provides excellent insulation and protection against heat and abrasion.

Brand New Connectors: All connectors are brand new and ready for installation, ensuring a perfect fit. We prioritise genuine connectors whenever possible, and when they are not available, we use high-quality replacement connectors to ensure reliability and performance.

Clearly Labeled: Each branch of the loom is clearly labeled for easy identification and installation.

Allowance for additional connections: Including provisions for a fuel pressure sensor, flex fuel sensor and a 4 pin DTM Deutsch connector to connect CAN Bus devices such as a digital dash or a wideband O2 sensor.

Comes with documentation showing ECU/Connector pinouts etc

At Evolving Motorsport we also offer custom wiring loom solutions tailored to your specific setup from street cars to full race cars.

Please Note: Depending on ECU this item may need to be made to order please allow 7-10 days.